Replacing the bulb in the oven Bosch

How to replace a bulb in the oven oven?

Before you start twisting and pulling the “stuck” oven cover, use the torch to make sure that there are no small screws that you first need to remove. If you have, take a screwdriver and unscrew the screws. The cover of the light bulb should be easily removed.

Bosch positions light in the main (lower) oven in the far right corner so it is difficult to get the purchase on it. I will never know if I could delete it without a tool, just using my hand, if I took all of the above steps.

Replacing the bulb in the oven Bosch

Messages about the faults with Eesli on the display appears an error with the letter E, click the button

Day. In this case, the error message will go out. If a

When the errors appear E101, E104 and E106

You can continue to use the microwave mode.Error message E011 signals that,

Perhaps stuck one of the buttons. Click in turn all

Buttons and check if they are clean. If an error message

Continues to flash, contact the service.

The bulb in the oven can be replaced. Heat.Resistant

Halogen bulbs 12 V, 20 watts can be purchased in

Service or specialized stores.

Do not replace the light bulb in the oven if the device

Switched on. Disconnect the device from the mains or turn off

Appropriate fuse fuse.

Indication: Always take out a new halogen bulb from

Packaging only with a dry towel. This will extend the service life

Disconnect the fuse in the fuse unit.2. In order to avoid damage, put in a cold oven

Remove the glass ceiling. To do this, raise it

If it is removed hard, use a spoon. (Rice. A)

Remove the light bulb and replace it with a light bulb of the same type.

How to replace an oven lamp & bulb

Install a glass ceiling in place. (Rice. C)

Remove the dish towel. Turn on the fuse again

In the fuse block or insert a network into the outlet

If the door seal is damaged, it must be replaced.

A spare seal for the device can be purchased in

Service or in a business store. Wherein

You need to specify the product number (number E) and the factory number

Lamp Cover Removal Tools for Bosch, Neff and Siemens Ovens.

replacing, bulb, oven, bosch

Do not use the device if the door is damaged.

The energy of the energy of the microwaves is possible to the outside. The device is possible

Will use only after repair.

Open the oven door.2. Remove the old door seal.3. 5 hooks are fixed on the sealant. With these

Replacing the bulb in the oven Bosch

If the light bulb in the oven blocks, it needs to be replaced.

See also  How is the microwave oven different

Spare bulbs resistant to high temperatures

With a capacity of 40 W can be purchased in the service or in

Specialized stores. Use only these

Disconnect the fuse in the fuse unit.

In order to avoid damage, put in a cold oven

Remove the ceiling, turning it counterclockwise.

Insert a new light bulb of a similar type.4. Set the plafon to place.5. Remove the kitchen towel from the oven and turn on

If the light bulb in the oven blocks, it needs to be replaced.

Spare bulbs resistant to high temperatures

With a capacity of 25 W can be purchased in the service or in

Specialized stores. Use only these

Disconnect the fuse in the fuse unit.

In order to avoid damage, put in a cold oven

Remove the glass ceiling. To do this, pick up

Plane from below (rice. A). If the glass ceiling is removed from

Work, use as auxiliary

Turn the light bulb and replace it with a light bulb of the same type

(rice. B). When entering, make sure that the light bulb

Install a glass ceiling in place. Make sure that he

It was turned on the convex side to the right. Insert first

Plaphon from above, and then press tightly from below (rice. C).

Remove the kitchen towel from the oven and turn on

The damaged ceiling must be replaced. Original

Plafs can be purchased through the service service. Wherein

You need to specify the product number (number E) and the factory number

If your device needs to be repaired, our service service

replacing, bulb, oven, bosch

Always at your service. We always try to find

A suitable solution to avoid unnecessary

For qualified service when calling

Service specialist, be sure to indicate the number

Products (number E) and factory number (FD number) of your

Device. The branded plate with the numbers is located on the right

On the side of the oven door. So as not to waste time on

Search for these numbers, enter them and the phone number

Please note that the visit of the service specialist

To eliminate damage associated with the wrong

Caring for the device, even during the operation of the guarantee is not

Application for repairs and consultation during problems Contact details of all countries you will find in the attached

List of service centers.Rely on the competence of the manufacturer. Then you can

Why does the Bosch oven lamp are constantly on?

Poor connection in the lamp mount can lead to lamp burning., Especially if your oven is old or the shelves, a baking sheet or pan, causes an extremely high level of heat on the lamp, which the lamp burns out.

Turn the glass cover of the lamp to remove it. Putting on protective gloves, carefully remove the lamp from the housing. If you get stuck, carefully apply the pressure to twist or pull the light bulb until it is knocked out. Be careful if the light breaks when pressing.

Why does the Bosch oven lamp are constantly on?

Poor connection in the lamp mount can lead to lamp burning., Especially if your oven is old or the shelves, a baking sheet or pan, causes an extremely high level of heat on the lamp, which the lamp burns out.

Turn the glass cover of the lamp to remove it. Putting on protective gloves, carefully remove the lamp from the housing. If you get stuck, carefully apply the pressure to twist or pull the light bulb until it is knocked out. Be careful if the light breaks when pressing.

See also  Which gas or electric

Look into the instructions for the device

Usually in the passport that attaches to the oven, the type of lamp connector and its power are described in detail. Data on this is contained on the page dedicated to the lighting source, or on the schematic image of the device, under which explanations are given to each constructive element captured in the figure.

If the book was lost or the necessary information was not found in it, which happens very rarely, the oven user can use the Internet. Typically, manufacturers of household appliances post instructions for its use in free access so that anyone can familiarize themselves with them. Also, the necessary information about the light bulb can be found on thematic forums that are devoted to the repair or experience of the operation of a particular equipment. The user can ask a question in communities for repairing household appliances on social networks.

Where the number of the oven model is Bosch?

The model number can usually be found on the label inside the device, visible with the lower box of the freezer put forward. To order repairs online, click here. The model number can usually be found on the label under the device or under the base on which it is installed.

If power is supplied to the outlet, but the oven lamp does not work, this means that the light outlet is faulty. If the lamp cartridge is faulty, replace it. To determine whether the light switch is faulty, use the multimeter to check it for integrity. If the light switch does not work, replace it.

How to replace the lighting lamp in the frying cabinet

Replacing the lighting lamp in the oven does not pass without difficulties. In the process, the most important thing is not to touch a fragile cap. It is necessary to clearly follow the instructions for replacing the lamp. This approach will ensure a long operation of the device.

Lamps in gas and electric plates change similarly to each other. However, the process of replacing unlike models can be performed in different ways. First you need to turn off the heat cabinet itself. Let him cool, especially after cooking. The warmer the oven itself, the more difficult it is to unscrew the lamp and the cap. The last element must be twisted before the lamp itself. A faulty lighting device also needs to be pulled out. Check out the operating manual for your oven to determine which of the devices is suitable for the device. Only after familiarization can you buy a new lighting lamp. Then install it with the cap. Check the lamp performance. There are times when there is no suitable lamp for certain oven cabinets on sale. In this case, try to avoid damage to the lighting device and take care of the technique.

The oven cabinets of the brand in question interact differently with lighting lamps. Electrolux plates have a removable glass. And it is attached to the latch. To remove it, you need to press a light with a screwdriver. Disconnection will occur and the detail can be pulled out. Then unscrew the old lamp and connect the new.

You can replace the lamp in two ways: 1. A method of replacement, as in the oven Electrolux; 2. Using a partial disassembly of the heat cabinet; In the case of analysis of the oven, you must contact the service center.

See also  Glass replacement on a gas hob

Replacing the lamp in the oven of this brand occurs according to the standard process: 1. Unscrewing the cap; 2. Removing the cap; 3. Lamp twisting; Hansa cap in frying cabinets has ribs. Having taken up for them and it is necessary to twist the device. In case of lack of strength, press the rag to the cap. After turning, the cap is removed by the progressive movement.

The most suitable lamp for most ovens

Most often used devices with the basement E14. Such a base is available in halogen and incandescent lamps. In the guide for the oven of a certain model, it is necessary to clarify which of the basements is most suitable. There are times when the plate interacts only with a smooth base. Typically used lamps with capacities 25W and 40W are. The main differences between them are in the consumption of power and the power of the backlight. They also differ from each other’s life: 1. 40W. 2-5 years; 2. 25W. Eternity; Usually for easy cooking in the kitchen, chosen lamps with a capacity of 25W. For baking or other similar process requiring long.Term baking, you need to buy lighting on 40W. Backlight lamps must withstand heating up to 300 ° C and above. The set temperature is indicated on the packaging of the lighting product. This applies to halogen lamps.

You must be careful with halogen lamps due to mercury inside. If the lighting device crashes, immediately collect the fragments. Otherwise, mercury can get to suitable food. It is more convenient to collect fragments with a brush. After you collected fragments, you need to throw a brush. Process the surface with a potassium permanganate from a spray gun. Thus, the halogen lighting device will burn brighter than before.

You need to replace the lighting lamp very carefully. There is a risk that the glass will break or deteriorate to such an extent that for further work the device may no longer fit. In order to find out if the lamp is suitable for your device, carefully read the operating instructions. Each leadership says what a basic lamp is at and how to install it correctly.

No steam supply / weak steam feed. From 1,500 ₽

Type of repair / services Price
Water canister replacement 1 500 ₽
Elimination of system leaks (in t.H. Replacing hoses) 2 640 ₽
Replacing steam generator / evaporator 3 750 ₽
Replacing the pump 3 750 ₽
Replacing the power module 3 750 ₽
Replacing the steam generation module 3 750 ₽
Group of devices Description of technology Price
Oven cabinets Full.Size and compact devices with the presence of one or more additional function (mode): steam, microwaves, pyrolysis 492 ₽
microwaves Sensory devices 492 ₽
Plates Sensory devices 492 ₽
Double boots All types of devices 492 ₽

29 61 29 61 round.The.Clock support

You can also place an order for the call of the master at home online. To do this, just fill out a short form.

| Denial of responsibility | Contacts |RSS